Stacking Rack,Stack Rack,Rack Stack,Stackable Can Rack Nanjing Chinylion Metal Products Co., Ltd , https://www.clrack.com
(1) The vertical and horizontal guide rails of the worktable should be filled with high grade grease every week for lubrication.
(2) Slide the rails up and down. Lubricate the industrial butter every month.
(3) Inclined cutting device The screw nut should be lubricated with advanced grease each month.
(4) The storage screw guide rail screw nut shall be lubricated with No. 40 oil per shift.
After the end of processing, the operator shall clean the CNC foam cutting machine tool, mainly in the following aspects.
(1) The machine should be wiped clean immediately after processing, and a layer of engine oil should be applied on the surface of the table.
(2) Clean up the electro-erosion materials attached to the machine's wire feeding system, such as the guide pulley and the conductive block, so as not to cause vibration of the wire electrode during processing, or even cause the wire electrode to short-circuit with the machine tool, resulting in abnormal cutting.
(3) After processing for a period of time, there will be electro-deposited material in the working fluid tank. Each time the working fluid is replaced, daily detergent can be used to dilute the water. The clean fluid is used to scrub the working fluid chamber and the filter mesh. Finally, Rinse with clean water and inject clean working fluid.
Cleaning and Lubrication Method of CNC Foam Cutting Machine
In addition to cleaning the numerical control foam cutting machine, the operator must always lubricate the moving parts of the machine, mainly in the following aspects.