How to solve the bucket hopper hopper with slip? The correct solution is to untie the hopper with the joint, adjust the tensioning device on the bottom wheel to the highest position, and put the hopper belt into the hoist head through the head wheel. Connected to the bottom wheel and connected end to end, so that the hopper belt is in a state of being tensioned and not tensioned. The tensioning device is then fully tensioned. At this time, the tensioning stroke of the adjusting screw of the tensioning device that has not been utilized should not be less than 50% of the full stroke. When the hoist is overloaded, the resistance increases, causing the hopper belt to slip. At this point, the amount of material to be fed should be reduced and the feeding should be uniform. If the amount of feed is reduced, the slippage cannot be improved. It may be that the material in the machine is too much or the hopper is stuck by the material. It should be stopped for inspection and the fault should be eliminated. The inner surface of the head wheel drive shaft and the hopper belt is too smooth, which reduces the friction between the two, causing the hopper belt to slip. At this time, a layer of glue can be applied to the inner surface of the drive shaft and the hopper belt to increase the friction. The head and bottom wheel bearings do not rotate, and the resistance torque increases, causing the hopper belt to slip. At this time, it is possible to remove and wash the oil or replace the bearing. The Qing Sword, also known as the "Qing Dao" or "Qing Dynasty Sword," is a traditional Chinese weapon that originated during the Qing Dynasty (1644-1912). It is a type of straight, double-edged sword that was commonly used by the military and martial artists during this period. Chinese Sword Qing, Qing dynasty sword, Qing jian sword Ningbo Autrends International Trade Company , https://www.longquan-swords.com
The Qing Sword typically has a slightly curved blade with a length ranging from around 70 to 100 centimeters. The blade is made of high-quality steel and is known for its sharpness and durability. The hilt, or handle, of the sword is usually made of wood or bone and is often adorned with decorative elements such as carvings or metal fittings.
One distinctive feature of the Qing Sword is its guard, which is typically in the shape of a circular or oval ring. This guard not only protects the hand of the wielder but also provides balance and stability to the sword during combat. The pommel, or end of the hilt, is often shaped like a horse's hoof, representing the military association of the Qing Dynasty
How to solve the bucket hopper hopper with slip
The bucket elevator uses the friction between the hopper belt and the head wheel drive shaft to lift the material. If the hopper belt tension is insufficient, the hopper belt will slip. At this time, stop immediately and adjust the tensioning device to tighten the hopper belt. If the tensioning device does not fully tension the hopper belt, the stroke of the tensioning device is too short and should be readjusted. This is not the ultimate solution.