Buffalo Grove house fire 12/7

<

Buffalo Grove firefighters responded to a call about a smoking outdoor light fixture before receiving an additional report of a possible house fire late last night on Buckthorn Terrace. When the first engine arrived, they observed smoke and the incident was escalated to a working fire (Code 4). The homeowner had just returned home when the fire department arrived. The house was filled with smoke, and a small fire was visible in the rear. Upon entering, firefighters encountered heavy smoke and then discovered fire in the 'C-D' corner of the structure. The fire eventually vented through a second-story window as interior crews advanced their lines. One firefighter suffered minor injuries and was taken to the hospital for treatment before being released. Fire departments from Arlington Heights, Lincolnshire-Riverwoods, and Long Grove provided assistance, while Barrington sent an ambulance for rehab and a Wauconda unit transported the injured firefighter.

Larry Shapiro submitted these images, and you can view his full gallery here.

Buffalo Grove Fire 605 Buckthorn Terrace December 7, 2010

Buffalo Grove firefighters make entry through the front door with heavy smoke conditions inside. Larry Shapiro photo

Buffalo Grove Fire 605 Buckthorn Terrace December 7, 2010

A firefighter works off the bucket of Buffalo Grove's new Ferrara tower ladder to take out the second floor windows for ventilation. Larry Shapiro photo

Buffalo Grove Fire 605 Buckthorn Terrace December 7, 2010

Fire self vents through a second floor rear window as interior companies down the hall advance. Larry Shapiro photo

Buffalo Grove Fire 605 Buckthorn Terrace December 7, 2010 Ferrara engine

Buffalo Grove Engine 26 (217) was the first unit on the scene and took a hydrant just past the house. Three hand lines were used off this rig to fight the fire. Larry Shapiro photo

Buffalo Grove Fire 605 Buckthorn Terrace December 7, 2010 Lincolnshire-Riverwoods FPD squad 51

Lincolnshire-Riverwoods FPD Squad 51, a Pierce Dash HDR, setup just past the tower ladder and deployed a Wil-Burt light tower to illuminate the scene in addition to running several small lights around the house for supplemental lighting. Larry Shapiro photo

Sand Pump

Oilfield Drilling Mud Single-stage Pump Centrifugal Sand Pump

SB Series Centrifugal pump is used for transferring slurry or mud or water. It can be used as feeding pump for Desander, Desilter, or used as mixing pump for Jet Mud Mixer. Also it can be used as trip pump, and supercharging pump for rig Mud Pump. All our model centrifugal pump use tungsten carbide mechanical seal, with famous brand Bearing. And spare parts interchangeable with most of the international Brand pump which helps customer to source spare parts easily. Open impeller design that lowers axial thrust loads, and make it easier for installation, repair and maintenance.

Sand Pump,Centrifugal Sand Pump,Petroleum Drilling Sand Pump,Solids Control System Sand Pump

Henan Youlong Petroleum Engineering Technology Co.,Ltd , https://www.youlongenergy.com