Today, Xiao Bian collected the installation steps of the GPS sensor for the mixer's forward and reverse Hall sensors, letting the owners of mixing trucks know about it. 1. First, temporarily connect the sensor probe with the bracket and fix it in one place. In the whole part, it is close to the detection position of the shaft and the wheel (note that the probe is separated from the magnetic steel, and the magnet is fixed on the shaft or wheel of the drum); Open the screws and adjust the sensor distance before tightening the screws. 2. After the circuit is properly connected, the drum of the cement mixer truck is in a rotating state. Observe the flickering of the sensor light (when forward rotation: the indicator light is steady green, only the magnetic steel flashes when passing through the probe; when it is reversed: the indicator light is red The light is always on, only the magnet flashes when passing through the probe; when it is stopped: the indicator light flashes red; pay special attention to when the magnet is in the position of the probe when the magnet is stopped, the indicator light does not shine, it is also normal). The indicator flashes in the wrong condition. Rotate the sensor probe until the indicator light flashes. 3. After fixing the sensor angle, fix the sensor probe and bracket, and place a drop of screw fastening glue between the bracket and the sensor fixing clamp and the original vehicle screw to prevent the screw from loosening. 4. Only the S pole of the magnetic steel can work normally for the sensor probe, and the other side can't work towards the sensor probe (when working or not, please refer to the blinking condition of the sensor indicator; the indicator light of the magnetic steel S pole changes towards the sensor probe; The indicator light does not change when the magnet faces the sensor probe on the other side.) Note: The trajectory of the magnet follows the line drawn on the probe.
The heat-conducting oil is used as the me dium for heating. the segment heating design. Low energy consumption. uniform he at conduction. automatic pressure kee ping and heat preservation. Adopting three-plate two- pressure design. the hot-pressed aluminum honeycomb core board has good bonding effect, flat- ness and no deformation.
Metal Composite Panel Line,Alpolic Metal Composite Panels,Alu Metal Composite Panel,Aluminium Composite Metal Panel Zhangjiagang Zhong Lai Machinery Co.,Ltd. , https://www.alumajor.com